CS-031: COMBINED CYCLE POWER PLANT
This case study demonstrates the modeling of a Combined Cycle (CC) power plant of a High Temperature Gas-Cooled Reactor (HTGR). The nuclear reactor is not modeled in detail as the focus of this case study is not on the reactor but on the CC Power Conversion Unit (PCU).
Share This:
Share This:
More Case Studies
You might also be interested in these CASE STUDIES
CS-063: Modelling of Spacecraft Propulsion System Priming in Flownex
This case study shows how Flownex was used as a tool to model a fuel feed system’s priming procedure, recording dynamic pressures during a transient simulation and investigating
CS-062: Lightweight Pressure Regulator for Space Launch Vehicles
This case study focuses on the design of a regulator for a suborbital launch vehicle developed by the Aerospace Systems Research Institute, utilizing Flownex to simulate and ensure
CS-061: GAS TURBINE COMBUSTOR DESIGN
This case study demonstrates how Flownex was used to model three combustor types—two annular and one reverse flow—showing its effectiveness in handling complex geometries, avoiding numerical issues, and
CS-060: ROCKET ENGINE FEED CYCLES AND COOLING TECHNIQUES IN FLOWNEX
This case study details the investigation conducted by UKZN’s Aerospace Research Institute into the development of a Commercial Launch Vehicle (CLV) for South Africa, utilizing Flownex to model
CS-059: Fuel Flexible Combustion System Modelling with Zero Carbon Fuely
This case study explores the use of 1D flow modeling to efficiently simulate hydrogen combustion systems, focusing on characterizing pressure drop over the burner to enhance energy savings…
CS-058: COMPARISON BETWEEN FLOWNEX SE AND EXPERIMENTAL DATA FOR A TRANSIENT WATER HAMMER EVENT
This case study demonstrates the capability of Flownex to simulate the water hammer effect by simulating the sudden closure of a valve at the outlet of a long