This case study demonstrates the use of Flownex to estimate the thickness of expected ice layer build-up on the outside surface of a low temperature emergency vent flare stack.
More Case Studies
You might also be interested in these CASE STUDIES
CS-084_Regenerative Burner
This case study shows how Flownex was used to model a regenerative burner and quantify its waste-heat-recovery efficiency.
CS-083_Dynamic Modelling of a Sodium-Cooled Fast Reactor During a Loss-of-Flow Event
This case study describes how Flownex was used to model axial turbines stage-by-stage using a nozzle-based approach that reproduces turbine behavior accurately even when limited geometric data is
CS-089: Simulating Tailings Transfer Upgrades
This case study describes how Flownex was used to model axial turbines stage-by-stage using a nozzle-based approach that reproduces turbine behavior accurately even when limited geometric data is
CS-082: Accurate Stage by Stage Axial Turbine Modelling with Minimal Geometry
This case study describes how Flownex was used to model axial turbines stage-by-stage using a nozzle-based approach that reproduces turbine behavior accurately even when limited geometric data is
CS-080:Predicting Combustor Wall Temperatures Using Thermal Fluid Network Modelling
This case study shows how Flownex thermal-fluid network model was used to predict the temperature distribution along the conical bluff body of an academic combustor. The model is
CS-081: Exhaust Gas Recirculation on Gas-Turbine Engine
This case study shows how Flownex was used to evaluate and optimize condensate extraction pump (CEP) flow control at a 4100 MW coal-fired power station. The plant originally