CS-037: INSULATION FLOW BALANCING
This case study investigates the balancing of forced flow through a perforated flow distribution manifold situated between the thermal insulation and the bottom of a cylindrical test cavity that forms part of a highly specialized experimental facility. The purpose of the insulation and manifold is to adequately insulate the very high temperatures within the test section while still allowing forced flow of gas to enter at the bottom of the test cavity.
Share This:
Share This:
More Case Studies
You might also be interested in these CASE STUDIES
CS-077: Optimization of condensate extraction pump’s flow control
This case study shows how Flownex was used to evaluate and optimize condensate extraction pump (CEP) flow control at a 4100 MW coal-fired power station. The plant originally
CS-075: Optimising combustions and heat recovery in a thermal oxidiser
Fire protection systems are installed in power stations, petrochemical plants, warehouses, etc. to extinguish or suppress a fire.
This case demonstrates a transient analysis of the boiler head
CS-074: Transient Analysis of a Boiler Fire Safety System
Fire protection systems are installed in power stations, petrochemical plants, warehouses, etc. to extinguish or suppress a fire.
This case demonstrates a transient analysis of the boiler head
CS-072: Thermal-fluid Modelling of the Transient Behaviour of a Capacity-Controlled Underground Refrigeration Unit
The modular and mobile Air-Cooling Unit (ACU) was developed to perform spot cooling in remote underground locations for where traditional cooling approaches proved less effective. Flownex was used
CS-073: Transient Simulation of a Two-Stage Air Cycle Chiller
This case study demonstrates the transient operation of a two-stage Air Cycle Chiller using Flownex SE to model the closed-loop air system with compressors and a turbine, supporting
CS-071: Control Optimization with Flownex-LabVIEW Integration
This case study shows how integrating Flownex with LabVIEW enabled control system design on a simulated plant, removing the need for live start-ups and shutdowns to tune parameters.