CS-003: REGULATOR TEMPERATURE ANALYSIS
This case study examines the use of Flownex to simulate the temperature dynamics of pressure regulators at a gas-fired power station, focusing on their exposure to extreme cold during turbine start-up and evaluating the effectiveness of trace heating and insulation to prevent degradation of critical components.
Share This:
Share This:
More Case Studies
You might also be interested in these CASE STUDIES
CS-067: Design of Low Temperature Proton Exchange Membrane Fuel Cell System Components
This case study demonstrates the use of Flownex to model system components of a low-temperature proton-exchange membrane fuel cell (PEMFC), including the cathode-side air flow…
CS-066: Data Centre Free Cooling Analysis Using Flownex SE
This case study demonstrates how Flownex SE simulates free cooling in a data center using natural resources and weather data in a transient analysis to optimize…
CS-065: Validating a Scaling Procedure for Cryogenic Pressure Fluctuations
This case study illustrates how Flownex was used with a scaling procedure based on dimensional analysis to simulate transient pressure fluctuations in a scaled cryogenic fluid flow system,
CS-064: Design of a Mobile Liquid Rocket Engine Test Facility Fuel Feed System using Flownex
This case study highlights how Flownex was used to model the propellant feed system for the SAFFIRE rocket engine, determining tank pressure and flow characteristics, with results validated
CS-063: Modelling of Spacecraft Propulsion System Priming in Flownex
This case study shows how Flownex was used as a tool to model a fuel feed system’s priming procedure, recording dynamic pressures during a transient simulation and investigating
CS-062: Lightweight Pressure Regulator for Space Launch Vehicles
This case study focuses on the design of a regulator for a suborbital launch vehicle developed by the Aerospace Systems Research Institute, utilizing Flownex to simulate and ensure