CS-039: SHELL AND TUBE HEAT EXCHANGER – STEADY STATE
This case study demonstrates the steady-state thermal fluid simulation of a shell and tube heat exchanger. The shell and tube heat exchanger model can also be used in cycle analysis where it is used in conjunction with other models.
Share This:
Share This:
More Case Studies
You might also be interested in these CASE STUDIES
CS-077: Optimization of condensate extraction pump’s flow control
This case study shows how Flownex was used to evaluate and optimize condensate extraction pump (CEP) flow control at a 4100 MW coal-fired power station. The plant originally
CS-075: Optimising combustions and heat recovery in a thermal oxidiser
Fire protection systems are installed in power stations, petrochemical plants, warehouses, etc. to extinguish or suppress a fire.
This case demonstrates a transient analysis of the boiler head
CS-074: Transient Analysis of a Boiler Fire Safety System
Fire protection systems are installed in power stations, petrochemical plants, warehouses, etc. to extinguish or suppress a fire.
This case demonstrates a transient analysis of the boiler head
CS-072: Thermal-fluid Modelling of the Transient Behaviour of a Capacity-Controlled Underground Refrigeration Unit
The modular and mobile Air-Cooling Unit (ACU) was developed to perform spot cooling in remote underground locations for where traditional cooling approaches proved less effective. Flownex was used
CS-073: Transient Simulation of a Two-Stage Air Cycle Chiller
This case study demonstrates the transient operation of a two-stage Air Cycle Chiller using Flownex SE to model the closed-loop air system with compressors and a turbine, supporting
CS-071: Control Optimization with Flownex-LabVIEW Integration
This case study shows how integrating Flownex with LabVIEW enabled control system design on a simulated plant, removing the need for live start-ups and shutdowns to tune parameters.