CS-013: FUEL OIL DISTRIBUTION
This case study illustrates how Steinmüller used Flownex to simulate a fuel oil distribution network, comparing the current setup with proposed modifications, which enabled efficient design decisions and assessment of potential cost implications associated with the changes.
Share This:
Share This:
More Case Studies
You might also be interested in these CASE STUDIES
CS-077: Optimization of condensate extraction pump’s flow control
This case study shows how Flownex was used to evaluate and optimize condensate extraction pump (CEP) flow control at a 4100 MW coal-fired power station. The plant originally
CS-075: Optimising combustions and heat recovery in a thermal oxidiser
Fire protection systems are installed in power stations, petrochemical plants, warehouses, etc. to extinguish or suppress a fire.
This case demonstrates a transient analysis of the boiler head
CS-074: Transient Analysis of a Boiler Fire Safety System
Fire protection systems are installed in power stations, petrochemical plants, warehouses, etc. to extinguish or suppress a fire.
This case demonstrates a transient analysis of the boiler head
CS-072: Thermal-fluid Modelling of the Transient Behaviour of a Capacity-Controlled Underground Refrigeration Unit
The modular and mobile Air-Cooling Unit (ACU) was developed to perform spot cooling in remote underground locations for where traditional cooling approaches proved less effective. Flownex was used
CS-073: Transient Simulation of a Two-Stage Air Cycle Chiller
This case study demonstrates the transient operation of a two-stage Air Cycle Chiller using Flownex SE to model the closed-loop air system with compressors and a turbine, supporting
CS-071: Control Optimization with Flownex-LabVIEW Integration
This case study shows how integrating Flownex with LabVIEW enabled control system design on a simulated plant, removing the need for live start-ups and shutdowns to tune parameters.