FIRED HEATER PROCESS GAS

A client in the petrochemical industry sought help with regards to a fired heater employed on a plant. The client wished to perform thermal fatigue and stress analysis on the heater, especially during transient operating conditions such as start-up and on-off cyclic operations, where the possibility for large temperature gradients exists.
Share This:
Share This:
More Case Studies
You might also be interested in these CASE STUDIES
COMPARISON BETWEEN FLOWNEX® SE AND EXPERIMENTAL DATA FOR A TRANSIENT WATER HAMMER EVENT
This case study will describe how Flownex® was used to model a water hammer event in a pipe…
PRESSURE PIPING THICKNESS AND FLANGE RATING CALCULATION
This case study demonstrates the use of a script and a Generic 4D chart to enable Flownex® to calculate standards-compliant wall…
FIRED HEATER DESIGN
This case study demonstrates the implementation of an API 560 fired heater compound component in Flownex®. It also shows how…
NATURAL GAS COMBUSTION MODELLING
This case study demonstrates the use of Flownex® to model and analyse a natural gas combustion process. Several compound components…
COALESCING FILTER SIZING AND LIFE CYCLE ANALYSIS USING RATED AND SPECIFIED PRESSURE LOSS COMPONENTS
This case study discusses the sizing of a coalescer filter and demonstrates its fouling life cycle analysis using a Flownex® model…
BASIC IMMERSION FIRETUBE MODEL
This case study demonstrates the implementation of a basic immersion fire-tube model in Flownex and presents natural draft and forced draft examples.